Reduce reverb.
You can estimate the parameters by analyzing the reverb first.
When you click , you’ll see a white curve which shows the temporal shape of your reverb (how long it is, and how its power fades over time). Anything below the red line will be cut. You can adjust the red line with the parameters below.
- : Display a analysis of reverb tail.
- Reverb Threshold: Threshold after a spectral peak under which reverb will be attenuated.
- Reverb Length: Length of the threshold tail.
- Reduction Ratio: Ratio of attenuation, in percents.
- : Choose to reduce the reverb or the signal.
![[Tip]](skin/admon/tip.png) |
Tip |
|---|---|
|
It can takes some adjustments, the white curve being an approximation, not a ground truth analysis of the reverb. So try to remain as conservative as possible with the red line threshold to not cut too much from your signal, which could yield artefacts. |
