Clone Stamp and Eraser Tool | Spectralayers Pro 7 Tutorials
Clone the content from a user-defined source location to the current brush location.
Alt while clicking). After the source location has been defined the button will return to its initial, non-pressed state.
: Defines the source location by clicking in the spectrogram (or press
: Defines the units used to set the brush shape proportions.
Size: (Screen Units only) Defines the size of the brush in pixels.
Aspect Ratio: (Screen Units only) Defines the aspect ratio of the brush.
Width: (Spectral Units only) Defines the width of the brush in seconds.
Height: (Spectral Units only) Defines the height of the brush in hertz.
Hardness: Defines the hardness of the brush in percents.
Gain: Defines how much the content is amplified or reduced during cloning, in decibels.
A hard brush (100%) will have clear edges. A soft brush (0%) will have blurry edges.
Pressure Controls Strength: When pressed, this enables devices with pressure control to set the strength of the tool.
Aligned: When checked, the source location is a relative source location (distance to the source location). When unchecked, the source location is an absolute source location (time and frequency).
Sample All Layers: Use all layers to perform the cloning, not just the active layer.